 |
|
| We manufacture Razor Coil in galvanized and stainless steel. The loops are normally not clipped together in concertina fashion. This allows the razor coil to be installed in any distance between loops, depending on the security desired, the most common being 18” or 450 mm. Warning: We as a manufacturer recommend that all “Razor Coil” products are potentially dangerous and should be attached to walls and fences at a minimum height of eight feet. The installed material must avoid any and all contact with pedestrian traffic and be installed in a highly visible manner. Check local codes for more details. Razor coil is manufactured in 3 diameters – 18” – 24” – 36” (450-600-750 MM). It is fabricated from A 1” (26MM) wide and 0.020 (0.50 MM) thick strip of G 90 galvanized material or 430 stainless steel. Clusters of 4 needle sharp barbs are located 4” (100 MM) on center around each coil loop. Each barb is 1.2 when measured from the center of the cluster. The coil is cold pressed 230o around A 0.091 (2.3 MM) diameter high tensile galvanized or stainless steel core wire. When ordering the concertina each loop shall be clipped at the adjacent loop 3- 5 –7 or 9 times equally spaced around the circumference to provide the concertina effect. The clips are made of 0.065” X 0.0375 stainless steel capable of withstanding a minimum pull load of 200 LBS. |
|
|
|
